Inspection Procedure 3

Inspection Procedure 3: When the "CANCEL" Switch is Set to ON, Cruise Control System is not Cancelled.

COMMENT
The cause is probably an open-circuit in the output circuit inside the "CANCEL" switch.

TROUBLESHOOTING HINTS (The most likely causes for this case:)
- Damaged harness or connector.
- Malfunction of the cruise control switch.
- Malfunction of the clock spring.
- Malfunction of the ECM.

DIAGNOSIS

Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, check the data list item 75: Cancel switch.






CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

1. Connect scan tool MB991958 to the data link connector. Scan Tool Connecting
2. Turn the ignition switch to the "ON" position.
3. Set scan tool MB991958 to data reading mode for cruise control system. Reading Diagnostic Trouble Codes
- Item 75: Cancel switch.
- When the "CANCEL" switch is pressed, the display on scan tool MB991958 should be "ON".
- When the "CANCEL" switch is released, the display on scan tool MB991958 should be "OFF".

4. Turn the ignition switch to the "LOCK" (OFF) position.
5. Disconnect scan tool MB991958.

Q: Is the switch operating properly?

YES : Go to Step 2.

NO : Refer to Diagnostic Trouble Code Procedures - DTC 15: Cruise control switch system. DTC 15 Then go to Step 3.

STEP 2. Check the symptoms.

Q: "CANCEL" switch is pressed, cruise control system is cancelled?

YES : It can be assumed that this malfunction is intermittent (Refer to General (Body and Chassis), How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions).

NO : Replace the ECM [2.4L Engine] or ECM [3.0L Engine]. Then go to Step 3.

STEP 3. Check the symptoms.

Q: "CANCEL" switch is pressed, cruise control system is cancelled?

YES : The procedure is complete.

NO : Return to Step 1.