Operation CHARM: Car repair manuals for everyone.
Home >> Mitsubishi >> 2012 >> Eclipse L4-2.4L (4G69) >> Repair and Diagnosis >> Transmission and Drivetrain >> Manual Transmission/Transaxle >> Service and Repair >> Removal and Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal and Replacement




REMOVAL AND INSTALLATION [5M/T]

CAUTION:
*: Indicates parts which should be temporarily tightened, and then fully tightened after placing the vehicle horizontally and loading the full weight of the engine on the vehicle body.













- MB991454: Engine Hanger Balancer (chain)
- MB991527: Hanger
- MB991895: Engine Hanger
- MB991928: Engine Hanger
- Slide bracket (HI)
- MB991931: Joint (140)
- MB991932: Foot (standard)

REMOVAL SERVICE POINTS

[[A]] CLUTCH RELEASE CYLINDER DISCONNECTION

Remove the clutch release cylinder without disconnecting the oil line connection, and fix it to the vehicle chassis.

[[B]] TRANSAXLE MOUNT BRACKET REMOVAL

Jack up the transaxle assembly gently with a garage jack, and then remove the transaxle mount bracket.

[[C]] ENGINE ASSEMBLY SUPPORT









1. [Engine hanger MB991895 is used]
(1) Set special tool MB991895 to the front fender mounting bolts (A and B) and the radiator support upper insulator mounting bolts (C and D), which are located in the engine compartment, as shown.
(2) Set special tool MB991527 and MB991454 (chain) to hold the engine/transaxle assembly.













2. [Engine hanger MB991928 is used]
(1) Assemble the engine hanger (special tool MB991928). Set following parts to the base hanger.

- Slide bracket (HI)
- Foot (standard) (MB991932)
- Joint (140) (MB991931)
(2) Set the engine hanger (special tool MB991928) to the front fender mounting bolts (A and B) and the radiator support upper insulator mounting bolts (C and D), which are located in the engine compartment, as shown.
NOTE:
Adjust the engine hanger balance by sliding the slide bracket (HI).

(3)
(4) Set special tools MB991527 and MB991454 (chain) to hold the engine/transaxle assembly.

INSTALLATION SERVICE POINTS

]]A[[ TRANSAXLE MOUNT STOPPER INSTALLATION





Install the transaxle mount stopper so that the arrow mark points as shown in the illustration.
pro multis · About Operation CHARM