P1772

DTC P1772 LOW COAST BRAKE SOLENOID VALVE





Description
Low coast brake solenoid valve is turned "ON" or "OFF" by the TCM in response to signals sent from the PNP switch, vehicle speed sensor and accelerator pedal position sensor (throttle position sensor). Gears will then be shifted to the optimum position.




CONSULT-III Reference Value in Data Monitor Mode









On Board Diagnosis Logic
- This is an OBD-II self-diagnostic item.
- Diagnostic trouble code "P1772 LC/B SOLENOID/CIRC" with CONSULT-III or 7th judgement flicker without CONSULT-III is detected when TCM detects an improper voltage drop when it tries to operate the solenoid valve.




Possible Cause
- Harness or connectors
(The solenoid circuit is open or shorted.)
- Low coast brake solenoid valve




DTC Confirmation Procedure

NOTE:
If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch "OFF" and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "DATA MONITOR" mode for "ENGINE" with CONSULT-III.
3. Start engine.
4. Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
SLCT LVR POSI: "1" or "2"
GEAR: "1st" or "2nd" gear (LC/B ON/OFF)
5. If DTC is detected, go to "Diagnosis Procedure".

WITH GST
Follow the procedure "WITH CONSULT-III".




Diagnosis Procedure
1.CHECK INPUT SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select "SELECTION FROM MENU" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Start the engine.
4. Read out the value of "ON OFF SOL" while driving.
OK or NG
OK - GO TO 4.
NG - GO TO 2.
2.CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to Main Power Supply And Ground Circuit.
OK or NG
OK - GO TO 3.
NG - Repair or replace damaged parts.
3.DETECT MALFUNCTIONING ITEM
Check the following.
- The A/T assembly harness connector pin terminals for damage or loose connection with harness connector.
OK or NG
OK - Replace the control valve with TCM. Refer to Service and Repair.
NG - Repair or replace damaged parts.
4.CHECK DTC
Perform "DTC Confirmation Procedure".
- Refer to "DTC Confirmation Procedure".
OK or NG
OK INSPECTION END
NG - GO TO 2.