Wheel Sensors

WHEEL SENSORS


Removal and Installation







CAUTION:
- Be careful not to damage the sensor edge and sensor rotor teeth.
- When removing the front or rear wheel hub assembly, first remove the wheel sensor from the assembly. Failure to do so may result in damage to the sensor wires, making the sensor inoperative.
- Pull out the sensor, be careful to turn it as little as possible. Do not pull on the sensor harness.
- Installation should be performed while paying attention to the following, and then tighten the wheel sensor bolt to the specified torque.
- Before installing the wheel sensor, make sure there are no foreign materials (such as iron fragments) adhered to the pick-up part of the wheel sensor, to the inside of the wheel sensor mounting hole or on the rotor mounting surface.

FRONT WHEEL SENSOR

Removal
1. Remove the front wheel and tire. Refer to Conventional Tire And Wheel.
2. Partially remove the front wheel fender protector. Refer to Service and Repair.
3. Remove the wheel sensor bolt and wheel sensor.
4. Remove the harness wire from mounts and disconnect the wheel sensor harness connector.

Installation
Installation is in the reverse order of removal.

REAR WHEEL SENSOR

Removal
1. Remove the wheel sensor bolt and wheel sensor from the rear wheel hub and bearing assemblies.
2. Remove the harness wire from mounts and harness wire clips from the rear suspension member.
3. Disconnect the wheel sensor harness connector.

Installation
Installation is in the reverse order of removal.