Removal and Installation

PARKING BRAKE CONTROL


Removal and Installation


REMOVAL
1. Remove lower instrument panel LH. Refer to Instrument Lower Panel LH.
2. On models with floor shift, remove center console. Refer to Center Console.
3. Remove floor trim. Refer to Service and Repair.





4. Remove adjusting nut and discard.

CAUTION:
Do not reuse adjusting nut after removing it.
5. Remove the lock plate from the front cable.
6. Remove front cable retaining bolts and nut.
7. Disconnect return spring from equalizer.
8. Disconnect right and left rear cables from equalizer.
9. Remove rear disc rotors. Refer to Rear.
10. Remove parking brake shoe, and remove rear cable from toggle lever. Refer to Service and Repair.
11. Remove right and left rear cables retaining bolts and nuts, then remove right and left rear cables.

INSTALLATION
Installation is in the reverse order of removal.
- Adjust parking brake. Refer to Testing and Inspection.

CAUTION:
Do not reuse adjusting nut after removing it.