With Intelligent Key System
VEHICLE SECURITY INDICATOR
Description
- Vehicle security indicator is built in combination meter.
- NATS (Nissan Anti-Theft System) and vehicle security system conditions are indicated by blink or illumination of vehicle security indicator.
VEHICLE SECURITY INDICATOR
Diagnosis Procedure
Regarding Wiring Diagram information, Intelligent Key Unit.
1.SECURITY INDICATOR LAMP ACTIVE TEST
With CONSULT-III
Check "THEFT IND" in "ACTIVE TEST" mode with CONSULT-III.
Without CONSULT-III
1. Disconnect BCM.
2. Check voltage between BCM harness connector M18 terminal
23 and ground.
Is the inspection result normal?
YES - Security indicator lamp is OK.
NO - GO TO 2
2.SECURITY INDICATOR LAMP CHECK
Check security indicator lamp condition.
Is the inspection result normal?
YES - GO TO 3
NO - Replace security indicator lamp.
3.CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect BCM and security indicator lamp connector.
3. Check continuity between BCM connector M18 (A) terminal 23
28. and security indicator lamp harness connector M24 (B) terminal
23 - 28 : Continuity should exist.
4. Check continuity between BCM connector M18 (A) terminal 23 and ground.
23 - Ground : Continuity should not exist.
Is the inspection result normal?
YES - Check the following:
- 10A fuse [No. 19, located in fuse block (J/B)]
- Harness for open or short between security indicator lamp and fuse
NO - Repair or replace harness.