For Mexico

DIAGNOSIS SYSTEM (ECM)

CONSULT Function


FUNCTION







WORK SUPPORT MODE

Work Item






SELF-DIAG RESULT MODE

Self Diagnostic Item
Regarding items of DTC and 1st trip DTC, Testing and Inspection.
How to Read DTC and 1st Trip DTC
DTCs and 1st trip DTCs related to the malfunction are displayed in "self-diag results".
- When ECM detects a 1st trip DTC, 1t" is displayed for "TIME".
- When ECM has detected a current DTC, "0" is displayed for "TIME".
- If "TIME" is neither "0" nor "1t", the DTC occurred in the past and ECM shows the number of times the vehicle has been driven since the last detection of the DTC.
How to Erase DTC and 1st Trip DTC
NOTE:
- If the ignition switch stays ON after repair work, be sure to turn ignition switch OFF once. Wait at least 10
seconds and then turn it ON (engine stopped) again.
- If the DTC is not for A/T related items (see Testing and Inspection), skip step 1.
1.Erase DTC in TCM. Testing and Inspection.
2.Select "ENGINE" with CONSULT.
3.Select "SELF-DIAG RESULTS".
4.Touch "ERASE". (DTC in ECM will be erased.)
Freeze Frame Data and 1st Trip Freeze Frame Data











DATA MONITOR MODE

Monitored Item





















NOTE:
Any monitored item that does not match the vehicle being diagnosed is deleted from the display automatically.

ACTIVE TEST MODE

Test Item











DTC & SRT CONFIRMATION MODE

SRT STATUS Mode
For items whose SRT codes are set, "CMPLT" is displayed on the CONSULT screen; for items whose SRT
codes are not set, "INCMP" is displayed.
SRT WORK SUPPORT Mode
This mode enables a technician to drive a vehicle to set the SRT while monitoring the SRT status.
DTC WORK SUPPORT Mode