Removal and Replacement

GENERATOR


Removal and Installation


VQ35DE

REMOVAL
1. Disconnect the negative battery terminal.
2. Drain engine coolant. Refer to Service and Repair.
3. Remove engine room cover.
4. Remove RH front wheel and tire assembly. Refer to Service and Repair.
5. Remove front/right-side engine undercover.
6. Remove air cleaner and duct assembly. Refer to Service and Repair.
7. Remove battery tray. Refer to Removal And Installation (Battery Tray).
8. Remove cooling fan assembly. Refer to Service and Repair.
9. Evacuate A/C system. Refer to Refrigeration System.
10. Remove the drive belt. Refer to Service and Repair.
11. Remove the A/C compressor. Refer to Service and Repair.
12. Remove idler pulley.
13. Remove A/C idler pulley.
14. Disconnect the oil pressure switch.
15. Disconnect the generator harness connectors.
16. Remove the generator bolt and nuts, using power tools.
17. Slide the generator out and remove.

INSTALLATION
Installation is in the reverse order of removal. Refer to Exploded View

CAUTION:
Be sure to tighten "B" terminal nut carefully.
- Install generator and check tension of belt. Refer to Testing and Inspection.
- For this model, the power generation voltage variable control system that controls the power generation voltage of the generator has been adopted. Therefore, the power generation voltage variable control system operation inspection should be performed after replacing the generator, and then make sure that the system operates normally. Refer to System Description.