Removal And Installation

ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Removal and Installation


CAUTION:
- When replacing the ABS actuator and electric unit (control unit), the calibration of the ABS actuator and electric unit (control unit) is required. Refer to "Description" Additional Service When Replacing ABS Actuator And Electric Unit (Control Unit).
- Before servicing, disconnect the battery cable from negative terminal.
- To remove brake tubes, use a suitable tool (flare nut wrench) to prevent flare nuts and brake tubes from being damaged. To install, use suitable tool (flare nut torque wrench).
- Do not apply excessive impact to ABS actuator and electric unit (control unit), such as by dropping it.
- Do not remove and install ABS actuator and electric unit (control unit) by holding harness.
- After work is completed, bleed air from brake tubes. Refer to "Bleeding Brake System" Service and Repair.
- After installing harness connector on the ABS actuator and electric unit (control unit), make sure connector is securely locked.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

REMOVAL

1.Disconnect battery cable from negative terminal. Refer to"Removal and Installation (Battery)" Removal And Installation.
2.Remove cowl top and cowl top extensions. Refer to "Removal and Installation" Removal And Installation.





3.Remove the power steering line hold down bracket.
4.Disconnect ABS actuator and electric unit (control unit) harness connector and place aside.
5.Loosen brake tube flare nuts using a suitable tool, then remove brake tubes from ABS actuator and electric unit (control unit) and place aside. Refer to "Exploded View" Exploded View.





6.Remove the harness bracket mounting bolt and place aside.
7.Remove ABS actuator and electric unit (control unit) and bracket as an assembly.
8.Remove bracket from ABS actuator and electric unit (control unit), if necessary.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
If ABS actuator and electronic unit (control unit) is replaced, after installation, adjust position of steering angle sensor. Refer to "Work Procedure" Work Procedure.