519419 Removing and Installing Cover for Rear Underbody

WM 519419 Removing and installing cover for rear underbody

Technical values





Preliminary work

Lift the vehicle. -> 400000 Lifting the vehicle

Removing cover for rear underbody





Installation position of cover for rear underbody

Information

Fastening nuts cannot be used again following removal.

1. Unscrew fastening screws -1- and fastening nuts -2, 4-.





Removing cover for rear underbody

2. Pull cover for rear underbody -3- out of the overlap.

Removing support for underbody cover





Installation position of cover for rear underbody

1. Unscrew fastening nut -1- and remove support -2-.





Removing support for underbody cover

2. Check support -2- and fastening nut -3- and replace if necessary.

Installing cover for rear underbody

Installing support for underbody cover





Installation position of cover for rear underbody

1. Position support -2- for underbody cover and tighten with the fastening nut -1-. Tightening torque => Tightening torque: 7 ftlb.+/-0.5 ftlb.





Installing support for underbody cover

Installing underbody cover





Installation position of cover for rear underbody

Information

When pushing in the underbody cover, make sure the overlap is correct.

1. Insert cover for rear underbody -3-.





Installing cover for rear underbody

2. Tighten fastening screws -1-. Tightening torque => Final tightening: 1.5 ftlb.+/-0.5 ftlb.
3. Tighten fastening nuts -2-. Tightening torque => Final tightening: 1 ftlb.+/-0.5 ftlb.
4. Tighten fastening nuts -4-. Tightening torque => Final tightening: 3.5 ftlb.+/-0.5 ftlb.

Subsequent work

Lower the vehicle. -> 400000 Lifting the vehicle