96151900 Removing and installing footwell light

WM 961519 Removing and installing footwell light

Removing footwell light

CAUTION

Danger of damage to property if bulbs are used or handled incorrectly!

- Risk of damage to bulbs and bulb housing.

-> Switch off ignition and remove ignition key.
-> To prevent short circuits, the load in question must be switched off while changing bulbs.
-> Only bulbs specified in the bulb table may be used.
-> Bulbs with a higher wattage may damage the bulb housing.
-> New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing bulbs.
-> In certain states, it is compulsory to carry spare light bulbs.





Footwell light overview





1. Press footwell light carefully out of the trim panel at the cutout -arrow- using a screwdriver.





Removing footwell light

2. Release plug on footwell light -arrows a- and pull it off.
3. Remove footwell light.

Installing footwell light

Information

Only use the relevant bulb specified in the bulb table => IN - Bulb table and installation instructions - "Information".





Overview of floor light, shown on the 911





1. Push plug on to footwell light until the plug is felt to engage.





Installing footwell light

2. Press footwell light into trim panel.