Console Shift Lever Bezel Replacement

Console Shift Lever Bezel Replacement

Removal Procedure

1. Remove the floor shift control boot and control knob from the floor console. Refer to Floor Shift Control Knob Replacement (Floor Shift Control Knob Replacement).
2. Remove the console storage bin. Refer to Front Floor Console Compartment Replacement (Front Floor Console Compartment Replacement).
3. Remove the ignition switch key bezel.
4. Starting at the rear of the bezel, lift the bezel to release the retaining clips.




5. Disconnect the electrical connector from the accessory power outlet.
6. Remove the bezel from the vehicle.

Installation Procedure




1. Position the trim plate to the console.
2. Connect the harness connector to the accessory power outlet.
3. Install the bezel to the console ensuring the retaining clips are fully seated.
4. Install the ignition switch key bezel.
5. Install the floor shift control boot to the floor console. Refer to Floor Shift Control Knob Replacement (Floor Shift Control Knob Replacement).
6. Install the console storage bin. Refer to Front Floor Console Compartment Replacement (Front Floor Console Compartment Replacement).