10. Timing Belt Removal

Timing Belt Removal

Tools Required

EN 46331 Timing Belt Tensioner Pulley Retaining Bolt





Important: The powertrain control module (PCM) must perform the idle learn procedure to determine the minimum throttle position and to establish idle speed when any of the following components are replaced:

* Throttle body

* Timing belt

* Timing belt drive sprocket

* Crankshaft and bearings

Refer to Idle Learn. Programming and Relearning

Use the EN 46331 to retain the tensioner pulley. Tighten until snug.




1. Loosen the idler pulley bolt (238) about 5 or 6 turns.




2. Remove the belt (235).
3. Remove the EN 46331.