Radio Replacement

Radio Replacement

Removal Procedure




1. Pull out on the accessory trim plate in order to release the retaining fasteners.
2. Disconnect the electrical connectors from the accessory trim plate.




3. Remove the screws from the radio and pull the radio out.

Important: The antenna cable uses a sliding snap-lock. Hold the sliding lock feature to disconnect from radio.

4. Push antenna lead toward radio to relieve tension on internal fingers.
5. Pull back on spring-loaded locking ring and disconnect from the radio.
6. Disconnect the radio electrical connectors and remove the radio.

Installation Procedure




1. Place the radio in the vehicle and connect the radio electrical connectors.

Notice: Refer to Fastener Notice.

2. Push the radio into position and install the screws.

Tighten the screws to 2.5 N.m (22 lb in).

3. Connect the electrical connectors to the accessory trim plate.




4. Align the retaining fasteners with the instrument panel.
Push on the outer edge of the accessory trim plate in order to secure the retaining fasteners.
5. Set up the radio.Refer to Programming and Relearning Programming and Relearning