Removal

BRAKE CONTROL: BRAKE ACTUATOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.

3. REMOVE WINDSHIELD WIPER ARM COVER Removal

4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

6. REMOVE HOOD TO COWL TOP SEAL Removal

7. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

8. REMOVE COWL TOP VENTILATOR LOUVER LH Removal

9. REMOVE FRONT WIPER MOTOR AND LINK Removal

10. REMOVE OUTER COWL TOP PANEL Removal

11. REMOVE AIR CLEANER ASSEMBLY Removal

12. REMOVE BRAKE ACTUATOR ASSEMBLY

(a) Release the lock lever and disconnect the brake actuator connector.

NOTICE:
Be careful not to allow brake fluid to enter the removed connector.

(b) Using a union nut wrench, separate the 6 brake tubes from the brake actuator.

HINT
* *1: To front wheel cylinder RH
* *2: To front wheel cylinder LH
* *3: To rear wheel cylinder RH
* *4: To rear wheel cylinder LH
* *5: From 1st master cylinder
* *6: From 2nd master cylinder

(d) Disengage the 2 tube clamps from the actuator bracket.

(e) Remove the 3 nuts and brake actuator with bracket.

NOTICE:
Do not damage the brake tubes or wire harness.

13. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY

(a) Remove the 4 bolts and actuator bracket.