Power Locks: Service and Repair

Power Door Lock

REMOVAL AND INSTALLATION

1. FRONT AND REAR DOOR, AND REAR GATE LOCK ACTUATOR
Refer to removal and installation of front door lock actuator, rear door lock actuators, and rear gate lock actuator.

NOTE: To remove and install the actuators, it is necessary to disassemble the door component parts.

2. DOOR LOCK TIMER




1. Remove glove box.
2. Remove back pocket cover.
3. Remove two bolts located at the rear of back pocket cover.
4. Remove instrument panel side right cover and bolt.
5. Remove clip located at the inside end of instrument panel.
6. Remove nut which secures door lock timer, and remove door lock timer from bracket while pulling right side lower end of instrument panel.

CAUTION: Be careful not to damage Instrument panel while pulling its right side lower end.

7. Disconnect connector from door lock timer.
8. Installation is in the reverse order of removal.