Body Control Module: Service and Repair
Body Integrated UnitREMOVAL
NOTE:
1. When replacing the body integrated unit
- Prepare the security ID plate.
- For models with immobilizers, prepare the required number of new (unregistered) immobilizer keys.
- When replacing the body integrated unit, check the current settings and record it.
2. After replacing the body integrated unit with immobilizer
- Register the immobilizer. For detailed operation procedure, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER"
- Set the current settings as recorded.
1. Disconnect the ground cable from battery.
2. Remove the driver's side instrument panel lower cover.
3. Remove the knee guard panel.
4. Disconnect the harness connector of body integrated unit.
CAUTION: Be careful to keep water and other foreign materials away from body integrated unit.
5. Remove two mounting nuts for body integrated unit bracket, and remove the body integrated unit.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)
NOTE: Make sure that there are no differences from the contents of the current settings after installation.