Rear Washer

REAR WASHER

INSPECTION

1. VISUAL INSPECTION
Check for the following items, and if any malfunction is found, replace the corresponding part.
- Make sure the nozzle and hose are not clogged.
- Make sure the hose is not bent.

2. INSPECTING THE SPRAY POSITION
1. Turn the wiper switch to OFF position.
2. While the vehicle is stopped, check that the washer spray position is as shown in the figure.
3. After inspection, if the spray position is really out of the specified range, replace with the new washer nozzle.

Spray position:
A: 72°
B: 45 mm (1.8 in)
C: 36 mm (1.4 in)