Installation

3UR-FE LUBRICATION: ENGINE OIL COOLER: INSTALLATION

INSTALLATION

1. INSTALL OIL COOLER SPACER

(a) Apply a light coat of engine oil to a new gasket.
(b) Install the gasket to the oil cooler spacer.

(c) Install the oil cooler spacer to the oil filter bracket with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
2. INSTALL OIL COOLER ASSEMBLY

(a) Apply a light coat of engine oil to 2 new O-rings.
(b) Install the 2 O-rings to the oil cooler.

(a) Apply a light coat of engine oil to 2 new O-rings.
(b) Install the 2 O-rings to the timing chain cover.

(c) Install the oil filter bracket with the 2 nuts and 2 bolts.
Torque: 35 Nm (357 kgf-cm, 26 ft-lbf)
4. INSTALL NO. 1 OIL COOLER BRACKET

(a) Connect the ground wire to the cylinder block.
(b) Install the oil cooler bracket with the 2 nuts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
5. INSTALL NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY

(a) Connect the 4 hoses.
(b) Install the water by-pass hose with the 3 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
6. CONNECT COOLER COMPRESSOR ASSEMBLY Installation

7. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY Installation

8. INSTALL OIL FILTER ELEMENT Replacement

9. INSTALL FAN AND GENERATOR V BELT Installation

10. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

11. ADD ENGINE OIL Replacement

12. ADD ENGINE COOLANT Service and Repair

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14. INSPECT FOR OIL LEAK Replacement

15. INSPECT ENGINE OIL LEVEL Testing and Inspection

16. INSPECT FOR COOLANT LEAK Testing and Inspection

17. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Installation

18. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

19. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH