Starter Relay: Testing and Inspection

1GR-FE STARTING: STARTER RELAY: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL





2. REMOVE STARTER RELAY
(a) Remove the relay block cover upper.
(b) Remove the starter relay.





3. INSPECT STATER RELAY
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance between the terminals.
Standard resistance:






If the result is not as specified, replace the stater relay.
4. INSTALL STATER RELAY
(a) Install the starter relay.
(b) Install the relay block cover upper.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)