Removal

BRAKE SYSTEM (OTHER): BRAKE BOOSTER: REMOVAL

REMOVAL

1. DRAIN BRAKE FLUID

NOTE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.

2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY Removal
3. DISCONNECT VACUUM HOSE ASSEMBLY
(a) Slide the clip and disconnect the vacuum hose from the check valve.
4. DISCONNECT BRAKE BOOSTER CONNECTOR
(a) Disconnect the 2 brake booster connectors from the brake booster.
5. REMOVE FRONT DOOR SCUFF PLATE LH Removal
6. REMOVE COWL SIDE TRIM BOARD LH Removal
7. REMOVE INSTRUMENT SIDE PANEL LH Removal
8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Removal
9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Removal
10. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT Removal
11. REMOVE PUSH ROD PIN
(a) Remove the clip and push rod pin.
12. REMOVE BRAKE BOOSTER ASSEMBLY





(a) Remove the 4 nuts, and then pull out the brake booster.
(b) Remove the gasket from the brake booster.
(c) Loosen the lock nut and then remove the clevis.
13. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY