Reassembly

STEERING COLUMN: STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column): REASSEMBLY

REASSEMBLY

1. INSTALL STEERING COLUMN BRACKET SPACER
(a) Fix the steering column in a vise between aluminum plates or a cloth. Then install the steering column bracket spacer to the steering column.
NOTICE:
- Install the steering column bracket spacer so that it is facing in the direction shown in the illustration.
- When using a vise, do not overtighten it.

2. INSTALL BREAK AWAY CAPSULE
(a) Install the 2 break away capsules and 2 break away collars to the steering column.
NOTE: Do not damage the plate spring of the break away collar.

3. INSTALL IGNITION SWITCH ASSEMBLY
(a) Attach the 2 claws to install the ignition switch to the steering lock.

4. INSTALL KEY INTERLOCK SOLENOID
(a) Install the key interlock solenoid to the steering lock with the 2 screws.

5. INSTALL UNLOCK WARNING SWITCH ASSEMBLY
(a) Attach the 2 claws to install the unlock warning switch to the steering lock.
6. INSTALL IGNITION SWITCH LOCK CYLINDER
(a) Check that the ignition switch lock cylinder is in the ACC position.

(b) Install the ignition switch lock assembly to the steering lock.
(c) Check that the ignition switch lock cylinder is securely installed.
7. INSPECT STEERING LOCK OPERATION
8. INSTALL UPPER STEERING COLUMN CLAMP WITH SWITCH BRACKET ASSEMBLY
(a) Temporarily install the steering column upper with switch bracket and the steering lock bracket with 2 new tapered-head bolts.

(b) Tighten the 2 tapered-head bolts until the bolt heads break off.
9. INSTALL TRANSPONDER KEY AMPLIFIER
(a) Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.

(b) Push the transponder key amplifier upward and install it to the upper bracket.
NOTE: Do not push the amplifier up with excessive force.

10. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
(a) Install the ECU with the 2 screws.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
(b) Connect the 2 ECU connectors.