Removal

WIPER AND WASHER: FRONT WIPER MOTOR: REMOVAL

REMOVAL

1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
(a) Remove the nut, wiper arm and blade.
2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
(a) Remove the nut, wiper arm and blade.
3. REMOVE HOOD TO COWL TOP SEAL

fig_refty09tundrG-E146298

(a) Using a clip remover, detach the 16 claws and remove the cowl top seal.
4. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
(a) Using a clip remover, detach the claw and remove the cowl side seal.
5. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
HINT: Use the same procedures described for the LH side.

6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

fig_refty09tundrG-E146299

(a) Remove the 2 clips.
(b) Detach the 8 claws and remove the ventilator louver.
7. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

fig_refty09tundrG-E146300

(a) Disconnect the connector.
(b) Remove the nut.
(c) Remove the 4 bolts and wiper motor and link assembly.
8. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

fig_refty09tundrG-E146303

(a) Using a screwdriver, disconnect the rod of the wiper link from the wiper motor as shown in the illustration.
HINT: Tape the screwdriver tip before use.

fig_refty09tundrG-E146306

(b) Remove the 3 bolts.

fig_refty09tundrG-E146302

(c) Rotate the crank arm clockwise and remove the wiper motor.