Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: INSTALLATION

1. INSTALL SPIRAL CABLE

(a) Engage the 6 claws and 2 pins, and install the spiral cable to the steering angle sensor.





2. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

(a) Check that the front wheels are facing straight ahead.

(b) Set the turn signal switch to the neutral position.

NOTICE:
If it is not in the neutral position, the turn signal switch pin may be snapped.

(c) Install the spiral cable with steering angle sensor with the 3 claws.





NOTICE:
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

(d) Connect the connectors to the spiral cable with steering angle sensor.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

3. INSTALL STEERING COLUMN COVER Installation

4. ADJUST SPIRAL CABLE

(a) Check that the ignition switch is off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Rotate the spiral cable counterclockwise slowly by hand until it stops.





NOTICE:
Do not turn the spiral cable using the airbag wire harness.

(d) Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.





NOTICE:
Do not turn the spiral cable using the airbag wire harness.

HINT
The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

5. INSTALL HORN BUTTON WIRE SUB-ASSEMBLY (w/o Steering Pad Switch and Cruise Control System)

(a) Connect the connector to install the horn button wire sub-assembly.

6. INSTALL STEERING WHEEL ASSEMBLY Installation

7. INSPECT STEERING WHEEL CENTER POINT

8. INSTALL STEERING PAD Installation

9. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

10. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

12. INSPECT STEERING PAD Installation

13. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.