Installation

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION

1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

(a) Engage the adjuster positioning hole with the claw and install the front shoulder belt anchor adjuster assembly with the 2 bolts.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

(a) Temporarily install the front seat outer belt assembly with the 2 bolts.





(b) Fully tighten the bolt [A] first, then the bolt [B] to install the front seat outer belt assembly.

Bolt [A] - Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

Bolt [B] - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

(c) Connect the connector and lock the locking button as shown in the illustration.





NOTICE:
Securely lock the locking button.

(d) Connect the shoulder anchor of the front seat outer belt assembly with the nut.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

3. INSTALL CENTER PILLAR GARNISH Installation

4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY

(a) Install the floor end of the front seat outer belt assembly with the bolt.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

(b) Check if the ELR locks.

NOTICE:
The check should be performed with the outer belt assembly installed.

(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.

5. INSTALL LOWER CENTER PILLAR GARNISH Installation

6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP Installation

7. INSTALL REAR DOOR SCUFF PLATE Installation

8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP Installation

9. INSTALL FRONT DOOR SCUFF PLATE Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

11. INSPECT SRS WARNING LIGHT

Diagnosis System