EPS Warning Light Circuit

POWER STEERING: POWER STEERING SYSTEM: EPS Warning Light Circuit
- EPS Warning Light Circuit

DESCRIPTION

If the power steering ECU detects a malfunction, the P/S warning light comes on. At this time, the power steering ECU stores a DTC in its memory.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK FOR DTC (CAN COMMUNICATION SYSTEM)

(a) Turn the ignition switch off.

(b) Connect Techstream to the DLC3.

(c) Turn the ignition switch on (IG).

(d) Turn Techstream on.

(e) Using Techstream, check for DTCs and confirm that there are no problems in the CAN communication system.

OK:

CAN DTCs are not output.

NG -- GO TO CAN COMMUNICATION SYSTEM
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (IG POWER SUPPLY)

(a) Enter the following menus: Chassis / EMPS / Data List.

(b) Select the item "IG Power Supply" in the Data List and read the value displayed on Techstream.

EMPS:

NG -- INSPECT FUSE (ECU IG1)
OK -- Continue to next step.

3. PERFORM ACTIVE TEST BY TECHSTREAM

(a) Enter the following menus: Body / Combination meter / Active Test.

(b) According to the display on tester, perform the "Active Test".

Combination meter:

*1: w/o Multi-information Display

*2: w/ Multi-information Display

OK:

Indicator comes on.

NG -- REPLACE COMBINATION METER ASSEMBLY How To Proceed With Troubleshooting

OK -- REPLACE POWER STEERING ECU Removal

4. INSPECT FUSE (ECU IG1)

(a) Remove the ECU IG1 fuse from the instrument panel junction block.

(b) Measure the resistance of the fuse.

OK:

Below 1 Ohms

NG -- REPLACE FUSE
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)

(a) Disconnect the connectors from the power steering ECU.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Enter the following menus: Body / Combination meter / Active Test.

(b) According to the display on tester, perform the "Active Test".

Combination meter: