Removal

WIPER AND WASHER: REAR WIPER MOTOR: REMOVAL

1. PRECAUTION

NOTICE:
* Be sure to use the centering jig when removing and installing the rear wiper motor assembly (for Glass Hatch Type). Failure to do so will result in a change of the location of the axis of the rear wiper motor assembly (for Glass Hatch Type), causing the wiping angle to change.
* After installing the rear wiper motor assembly (for Glass Hatch Type), do not open the glass hatch before installing the rear wiper link pivot.
* If the rear wiper motor assembly is removed without using the centering jig, the rear wiper motor assembly must be replaced with a new one.
2. REMOVE BACK WINDOW UPPER TRIM PANEL ASSEMBLY Disassembly

3. REMOVE BACK DOOR TRIM COVER LH (w/o Power Back Door) Disassembly

4. REMOVE BACK DOOR SERVICE HOLE COVER LH (w/ Power Back Door) Disassembly

5. DISCONNECT POWER BACK DOOR ROD (w/ Power Back Door) Disassembly

6. REMOVE BACK DOOR TRIM COVER LH (w/ Power Back Door) Disassembly

7. REMOVE BACK DOOR TRIM COVER RH Disassembly

8. REMOVE BACK DOOR LOCK COVER (for Glass Hatch Type) Disassembly

9. REMOVE ASSIST STRAP HOLE COVER Disassembly

10. REMOVE ASSIST STRAP ASSEMBLY Disassembly

11. REMOVE BACK DOOR TRIM PANEL ASSEMBLY Disassembly

12. REMOVE REAR WIPER SHAFT COVER (for Glass Hatch Type)

(a) Disengage the 3 clips and remove the rear wiper shaft cover.





13. REMOVE REAR WIPER ARM HEAD CAP

(a) Remove the rear wiper arm head cap.





14. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY

(a) Remove the nut and the rear wiper arm and blade assembly.





15. REMOVE REAR WIPER MOTOR GROMMET (for Fixed Glass Type)

(a) Remove the rear wiper motor grommet.





16. REMOVE REAR WIPER LINK CAP (for Glass Hatch Type)

(a) Remove the rear wiper link cap.





17. REMOVE REAR WIPER LINK PIVOT (for Glass Hatch Type)

(a) Remove the nut and the rear wiper link pivot.





18. REMOVE REAR WIPER MOTOR ASSEMBLY (for Fixed Glass Type)

(a) Disconnect the connector.





(b) Remove the 4 bolts and the rear wiper motor assembly.

NOTICE:
Be careful not to scratch the back door glass.

19. REMOVE REAR WIPER MOTOR ASSEMBLY (for Glass Hatch Type)

(a) When reinstalling the rear wiper motor assembly :

(1) Open the glass hatch.

(2) Engage the 3 claws and 2 guides, and then install the centering jig.





NOTICE:
* The centering jig cannot be reused.
* Do not remove the centering jig before installing the rear wiper link pivot.
(3) Close the glass hatch, and engage the 2 claws and guide.





NOTICE:
Be sure to engage the 2 claws and guide securely.

(4) Disconnect the connector.





(5) Remove the 2 nuts.

(6) Remove the 4 bolts and the rear wiper motor assembly.

NOTICE:
* Do not hold the rear wiper motor assembly by the rear wiper link pivot.
* Be careful not to scratch the back door glass.
(b) When using a new rear wiper motor assembly:

(1) Disconnect the connector.





(2) Remove the 4 bolts.

(3) Remove the 2 nuts and the rear wiper motor assembly.





NOTICE:
Be careful not to scratch the back door glass.