Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: INSTALLATION

CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Service Precautions.

1. INSTALL SPIRAL CABLE SUB-ASSEMBLY

(a) Check that the front wheels are facing straight ahead.

(b) Set the turn signal switch to the neutral position.

NOTICE:
Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.

(c) Install the spiral cable.









NOTICE:
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.

(d) Connect the connectors to the spiral cable.

NOTICE:
When handling the airbag connector, do not damage the airbag wire harness.

(e) Attach the 4 clips to the column cover (upper).





(f) Install the steering column cover (upper).





2. INSTALL STEERING COLUMN COVER (LOWER)

(a) Attach the 4 claws.





3. POSITION SPIRAL CABLE





(a) Slowly rotate the spiral cable counterclockwise by hand until it feels firm.

NOTICE:
Do not use the airbag wire harness to turn the spiral cable.

(b) Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.





NOTICE:
Do not use the airbag wire harness to turn the spiral cable.

HINT
The spiral cable will rotate approximately 2.5 turns to the left and right from the center.

4. INSTALL STEERING WHEEL ASSEMBLY Installation

5. INSTALL STEERING PAD ASSEMBLY Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. INSPECT STEERING PAD ASSEMBLY Installation

8. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Problem Symptoms Table.

9. INSPECT STEERING WHEEL POSITION