Programming and Relearning

SUPPLEMENTAL RESTRAINT SYSTEM: OCCUPANT CLASSIFICATION SYSTEM: INITIALIZATION

NOTICE:
Make sure that the front passenger seat is not occupied before performing the operation:

HINT
Perform zero point calibration and sensitivity check if any of the following conditions occur.

* The occupant classification ECU is replaced.
* Accessories (seatback tray and seat cover, etc.) are installed.
* The front passenger seat is removed from the vehicle.
* The passenger airbag ON/OFF indicator ("OFF") comes on when the front passenger seat is not occupied.
* The vehicle is brought to the workshop for repair due to an accident or a collision.
1. ZERO POINT CALIBRATION

(a) Zero point calibration and sensitivity check procedures.

HINT
Make sure that zero point calibration has finished normally, and then perform the sensitivity check.

(1) Check that all of the following conditions are met:

* The vehicle is parked on a level surface.

* No objects are placed on the front passenger seat.

* The front passenger seat belt buckle switch is OFF.

(2) Adjust the seat position according to the table below.





(3) Turn the ignition switch to the LOCK position.

(4) Connect the Techstream to the DLC3.

(5) Turn the ignition switch to the ON position and turn the Techstream on.

(6) Enter the following menus: Body Electrical / Occupant Detection / Utility / Zero Point Calibration.

(7) Perform the zero point calibration by following the prompts on the tester screen.

HINT
* Refer to the Techstream operator's manual for further details.
* If the zero point calibration does not complete, replace the front seat assembly RH.

OK:

"Zero Point Calibration is complete." is displayed.

2. SENSITIVITY CHECK

(a) Sensitivity check procedures

(1) Turn the ignition switch to the LOCK position.

(2) Connect the Techstream to the DLC3.

(3) Turn the ignition switch to the ON position and turn the Techstream on.

(4) Enter the following menus: Body Electrical / Occupant Detection / Utility / Sensitivity Check.

(5) Perform the sensitivity check by following the prompts on the tester screen.

HINT
Refer to the Techstream operator's manual for further details.

(6) Confirm that the beginning sensor reading within standard value.

Standard value:

-3.2 to 3.2 kg (-7 to 7 lb)

(7) Place a 30 kg (66.14 lb) weight (eg. a 30 kg (66.14 lb) of lead mass) onto the front passenger seat.

(8) Confirm that the sensitivity is within the standard value.

Standard value:

27 to 33 kg (59.52 to 72.75 lb)

HINT
* When performing the sensitivity check, use a solid metal weight (the check result may not appear properly if the weight made from liquid is used).
* If the sensitivity deviates from the specified range, retighten the bolts of the front passenger seat without deforming the seat rail. After performing this procedure, if the sensitivity is not within the specified range, replace the front seat assembly RH.