Removal

2TR-FE COOLING: RADIATOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Pre Runner and 4WD Type)

(a) Remove the 4 bolts, then remove the engine under cover No. 1.

3. DRAIN ENGINE COOLANT Service and Repair

4. REMOVE RADIATOR SUPPORT TO FRAME SEAL LH

(a) Disengage the 9 clips, then remove the radiator support to frame seal LH.

5. REMOVE FAN SHROUD

(a) Loosen the 4 nuts shown in the illustration.

(b) Remove the fan and generator V belt.

(c) Disconnect the radiator reserve tank hose from the radiator.

(d) Disconnect the oil cooler inlet and outlet hoses from the fan shroud. (for Automatic Transmission)

(e) Remove the 2 bolts shown in the illustration.

(f) Remove the 4 nuts, then remove the fan shroud and fan with fluid coupling together.

NOTICE:
Make sure that the fan shroud and fan with fluid coupling do not make any contact with the radiator when they are removed.

(g) Remove the fan pulley.

6. REMOVE RADIATOR ASSEMBLY

(a) Disconnect the radiator hose inlet.

(b) Disconnect the radiator hose No. 2.

(d) Remove the 4 bolts, then remove the radiator.