Removal

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY (for CrewMax): REMOVAL

HINT
* Use the same procedures for the LH side and RH side.
* The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
After the ignition switch is turned LOCK, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch LOCK, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE FRONT SEAT ASSEMBLY

(a) for Manual Seat:

Remove the front seat Removal.

(b) for Power Seat:

Remove the front seat Removal.

3. REMOVE FRONT DOOR SCUFF PLATE Removal

4. REMOVE REAR DOOR SCUFF PLATE Removal

5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

(a) Partially remove the front door opening trim weatherstrip so that the center lower pillar garnish and center pillar garnish can be removed.

6. REMOVE LOWER CENTER PILLAR GARNISH

(a) Detach the 2 claws and remove the cover.

(b) Remove the bolt and seat belt anchor.

(c) Detach the 7 clips and 2 claws, and remove the pillar garnish.

7. REMOVE CENTER PILLAR GARNISH Removal

8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the nut and shoulder anchor.

(b) Disconnect the pretensioner connector as shown in the illustration.