Operation CHARM: Car repair manuals for everyone.

Skid Control Buzzer Circuit





BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: Skid Control Buzzer Circuit
- Skid Control Buzzer Circuit

DESCRIPTION

The skid control buzzer sounds upon receiving a signal from the skid control ECU.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration Programming and Relearning.

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (SKID CONTROL BUZZER)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

(e) According to the display on the Techstream, read the Data List.

ABS/VSC/TRAC





(f) Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the Techstream.

Result





B -- REPLACE VSC ACTUATOR ASSEMBLY Removal
A -- Continue to next step.

2. INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL)

(a) Disconnect the H5 buzzer connector.





(b) Turn the ignition switch to ON.

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.

3. INSPECT SKID CONTROL BUZZER

(a) Disconnect the H5 buzzer connector.





(b) Apply battery negative voltage to terminal 1, and battery positive voltage to terminal 2 of the skid control buzzer, and then check that the buzzer sounds.

OK:

Skid control buzzer sounds.

Text in Illustration





NG -- REPLACE SKID CONTROL BUZZER ASSEMBLY Removal
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SKID CONTROL BUZZER)

(a) Disconnect the A19 ECU connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND)

(a) Disconnect the A19 ECU connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE VSC ACTUATOR ASSEMBLY Removal