Installation

1GR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL REAR ENGINE OIL SEAL





(a) Apply MP grease to a new oil seal tip.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST : 09223-78010

2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)





(a) Using SST, hold the crankshaft.

SST : 09213-54015

91651-60855

SST : 09330-00021

(b) Apply adhesive to 2 or 3 threads of the mounting bolt end.





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(c) Install the flywheel and 2 spacers onto the crankshaft.





(d) Using several steps, uniformly install and tighten the 8 mounting bolts in the sequence shown in the illustration.

Torque : 83 Nm (846 kgf-cm, 61 ft-lbf)

3. INSTALL DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transmission)





(a) Using SST, hold the crankshaft.

SST : 09213-54015

91651-60855

SST : 09330-00021

(b) Apply adhesive to 2 or 3 threads of the mounting bolt end.





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(c) Install the drive plate and 2 spacers onto the crankshaft.





(d) Using several steps, uniformly install and tighten the 8 mounting bolts in the sequence shown in the illustration.

Torque : 83 Nm (846 kgf-cm, 61 ft-lbf)

4. INSTALL TRANSMISSION ASSEMBLY Installation