Installation

2AZ-FE CHARGING: GENERATOR:

INSTALLATION

1. INSTALL GENERATOR ASSEMBLY





(a) Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.





(b) Install the generator assembly with the 2 bolts.
Bolt A - Torque: 21 Nm (215 kgf-cm, 16 ft-lbf)
Bolt B - Torque: 52 Nm (530 kgf-cm, 38 ft-lbf)





(c) Install the generator wire to terminal B with the nut.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
(d) Install the clamp bracket with the bolt.
Torque: 8.4 Nm (86 kgf-cm, 74 in-lbf)
(e) Attach the clamp and connect the generator connector to the generator.
2. INSTALL V-RIBBED BELT (Installation)

3. INSTALL FRONT FENDER APRON SEAL RH
4. INSTALL ENGINE UNDER COVER RH
5. INSTALL FRONT WHEEL RH (Installation)

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (Installation)