Removal
2AZ-FE ENGINE CONTROL: THROTTLE BODY: REMOVAL
1. DRAIN ENGINE COOLANT Service and Repair
2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Removal
3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE
(a) Disconnect the mass air flow meter connector.
(b) Separate the 2 wire harness clamps.
(c) Disconnect the No. 1 vacuum switching valve connector and the 2 fuel vapor feed hoses.
(d) Disconnect the ventilation hose.
(e) Loosen the No. 1 air cleaner hose clamp, release the 3 air cleaner assembly clamps and remove the air cleaner cap sub-assembly with hose.
4. REMOVE THROTTLE BODY ASSEMBLY
(a) Disconnect the 2 water by-pass hoses.
(b) Disconnect the throttle body assembly connector.
(c) Disconnect the throttle body hose.
(d) Remove the 4 bolts and throttle body assembly.
(e) Remove the gasket from the intake manifold.