B278A

THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM (w/ Smart Key System): B278A: Short to GND in Immobiliser System Power Source Circuit
B278A - Short to GND in Immobiliser System Power Source Circuit

DESCRIPTION

When there is a short to GND in the power supply for the transponder key amplifier of the engine switch, the certification ECU (smart key ECU assembly) stores this DTC.





* *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected





Related Data List and Active Test





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* Before replacing the certification ECU (smart key ECU assembly), refer to Registration Engine Immobilizer System (w/ Smart Key System).
* After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH)

(a) Disconnect the I78 certification ECU (smart key ECU assembly) connector.

(b) Disconnect the I58 engine switch connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

(a) Reconnect the I58 engine switch and I78 certification ECU (smart key ECU assembly) connector.

(b) Using an oscilloscope, check the waveform.





HINT
Perform this inspection on the engine switch side.

Measurement Condition





OK:

Waveform is output normally (refer to illustration).

Text in Illustration





Result:





B -- REPLACE ENGINE SWITCH Removal

C -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal

A -- REPLACE ENGINE SWITCH Removal