Vehicle Stability Control System

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

NOTICE:
Turn the ignition switch off before removing any parts.

HINT
* If no malfunction is found when inspecting parts, inspect the skid control ECU and ground points for poor connections.
* If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details, refer to the "See page" reference for the DTC.
* When 2 or more DTCs are detected, perform diagnosis for each DTC, one by one until the problem is identified.
* If DTCs were checked using the warning light or indicator light, refer to the tables in DTC Check/Clear to cross-reference them to the 5-digit DTCs shown in the following tables.
* Inspect the fuses and relays before inspecting the trouble areas shown in the following table.

ABS DTC









*: Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:

1. Drive the vehicle at 54 km/h (34 mph) for 3 seconds or more and check that the ABS warning light goes off.

2. Clear the DTCs.

VSC DTC





ABS Test Mode DTC