Removal

SEAT: REAR SEAT ASSEMBLY: REMOVAL

1. PRECAUTION

CAUTION:
* Be sure to read Precaution thoroughly before servicing.
for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor
for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor
* If the side airbag was deployed, replace the rear seat airbag assembly, rear side seatback frame sub-assembly, rear side seatback cover sub-assembly and rear side seatback pad with the necessary parts in accordance with the extent of the collision damage.
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR SEAT CUSHION ASSEMBLY

(a) Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.

NOTICE:
Follow the instructions below carefully as the cushion frame can be deformed easily.

(1) Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.





Standard Measurement





(2) Repeat the step above for the other hook.

(b) Remove the rear seat cushion assembly.

4. REMOVE REAR SEAT CUSHION LOCK HOOK

(a) Disengage the claw and remove the rear seat cushion lock hook.





NOTICE:
Rear seat cushion lock hooks must not be reused.

HINT
Use the same procedure for the RH side and the LH side.

5. REMOVE INNER LUGGAGE COMPARTMENT TRIM PAD

(a) Remove the inner luggage compartment trim pad.





6. REMOVE REAR SEATBACK ASSEMBLY LH

(a) Disengage the 2 fasteners as shown in the illustration.





Text in Illustration





(b) Remove the 2 bolts and rear seatback assembly LH.





NOTICE:
Be careful not to damage the vehicle body.

7. REMOVE REAR SEATBACK ASSEMBLY RH

(a) Disengage the 3 fasteners as shown in the illustration.





Text in Illustration





(b) Remove the 2 bolts and rear seatback assembly RH.





NOTICE:
Be careful not to damage the vehicle body.

8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

(a) Disconnect the rear seat outer belt from the rear seat shoulder belt guide.

(b) Disconnect the connector.

(c) Remove the 2 bolts.





(d) Disengage the hook and remove the rear side seatback assembly LH.

9. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

(a) Disconnect the rear seat outer belt from the rear seat shoulder belt guide.

(b) Disconnect the connector.

(c) Remove the 2 bolts.





(d) Disengage the hook and remove the rear side seatback assembly RH.