Programming and Relearning
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: CALIBRATION
1. DESCRIPTION
(a) Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration.
2. SYSTEM VARIANT LEARNING (When Using the Techstream)
(a) Perform System Variant Learning.
HINT
* System variant learning is automatically performed immediately after Test Mode is entered.
* If learning has not yet been performed, the slip indicator light will remains on and DTC C1288 (Error in Matching of ECUs) will be stored.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Switch the skid control ECU to Test Mode using the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Test Mode.
(6) Check that the ABS warning and slip indicator lights blink in the Test Mode pattern.
HINT
After the skid control ECU enters Test Mode, the slip indicator light may remains on for approximately 9 seconds before starting to blink in the Test Mode pattern.
(7) Turn the ignition switch off and disconnect the Techstream.
3. SYSTEM VARIANT LEARNING (When not Using the Techstream)
(a) Perform System Variant Learning.
HINT
* System variant learning is automatically performed immediately after Test Mode is entered.
* If learning has not yet been performed, the slip indicator light will remains on and DTC 88 (Error in Matching of ECUs) will be stored.
(1) Turn the ignition switch off.
(2) Using SST, connect terminals TS and CG of the DLC3.
SST : 09843-18040
Text in Illustration
(3) Turn the ignition switch to ON.
(4) Check that the ABS warning and slip indicator lights blink in the Test Mode pattern.
HINT
After the skid control ECU enters Test Mode, the slip indicator light may remains on for approximately 9 seconds before starting to blink in the Test Mode pattern.
(5) Turn the ignition switch off and disconnect SST from the DLC3.