Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL NO. 2 INSTRUMENT PANEL WIRE

(a) Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.





Text in Illustration





NOTICE:
* When connecting any airbag connector, take care not to damage the airbag wire harness.
* Be sure to only connect the connectors to each corresponding color.

(b) Push in the 2 locks to install the 2 airbag connectors to the instrument panel passenger airbag assembly.

(c) Engage the clamp.

2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

NOTICE:
If the hooks are not engaged in the correct order, the deployment part of the instrument panel passenger airbag assembly may be damaged.

(a) Engage the 3 hooks as shown in the illustration.





(b) Push the instrument panel passenger airbag assembly to engage the 3 hooks.

(c) Install the 2 screws to install the instrument panel passenger airbag assembly.

3. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY Installation

4. CONNECT NO. 2 INSTRUMENT PANEL WIRE

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the connector.





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

5. INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Installation

6. PERFORM DIAGNOSTIC SYSTEM CHECK

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor