Installation
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION
1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Engage the guide.
(b) Install the bolt [A] first, then the bolt [B] to temporarily install the front shoulder belt anchor adjuster assembly.
(c) Fully tighten the 2 bolts.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY Front Seat Outer Belt Assembly
3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
(a) Install the bolt [A] first, then the bolt [B] to temporarily install the front seat outer belt assembly.
(b) Fully tighten the 2 bolts.
Bolt [A] - Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
Bolt [B] - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(c) Connect the pretensioner connector and lock the locking button as shown in the illustration.
NOTICE:
Securely lock the locking button.
(d) Connect the shoulder anchor of the front seat outer belt assembly with the nut.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
4. INSTALL CENTER PILLAR UPPER GARNISH Installation
5. INSTALL CENTER PILLAR LOWER GARNISH Installation
6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY
(a) Install the floor anchor of the front seat outer belt assembly with the bolt.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(b) Check if the ELR locks.
NOTICE:
The check should be performed with the front seat outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
7. INSTALL LAP BELT OUTER ANCHOR COVER
(a) Engage the 3 claws to install the lap belt outer anchor cover.
8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
for LH Side: Installation
for RH Side: Installation
9. INSTALL REAR DOOR SCUFF PLATE Installation
10. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
for LH Side: Installation
for RH Side: Installation
11. INSTALL FRONT DOOR SCUFF PLATE Installation
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
13. INSPECT SRS WARNING LIGHT
for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor
for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor