Installation

REAR SUSPENSION: REAR LOWER ARM: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
* The rear No. 2 suspension arm assembly can be installed directly to the vehicle.

1. INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

(a) Temporarily tighten the rear No. 1 suspension arm assembly (inner side) with the bolt.





Text in Illustration





HINT
Ensure that the paint mark faces the rear of the vehicle.

(b) Set the rear No.1 suspension arm assembly in the position shown in the illustration, and fully tighten the bolt.





Torque : 100 Nm (1020 kgf-cm, 74 ft-lbf)

2. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

Installation

3. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY

(a) Temporarily tighten the rear No. 2 suspension arm assembly (inside) with the bolt.





Text in Illustration





HINT
Ensure that the paint mark faces the rear of the vehicle.

4. CONNECT REAR NO. 2 SUSPENSION ARM ASSEMBLY

(a) Connect the rear No. 2 suspension arm assembly (outer side) to the rear axle carrier sub-assembly with the bolt and nut.

NOTICE:
When temporarily tightening the bolt, keep the nut from rotating.

HINT
Insert the bolt from the rear of the vehicle.

5. STABILIZE SUSPENSION Installation

6. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY

(a) Fully tighten the 2 bolts.





Torque : 100 Nm (1020 kgf-cm, 74 ft-lbf)

7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)

Installation

8. INSTALL REAR WHEELS

Torque : 103 Nm (1049 kgf-cm, 76 ft-lbf)

9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Rear Wheel Alignment

10. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ Height Control Sensor)

Initialization

11. ADJUST HEADLIGHT AIMING (w/ Height Control Sensor)

Adjustments