Replacement

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: DIFFERENTIAL OIL SEAL: REPLACEMENT

1. DRAIN AUTOMATIC TRANSAXLE FLUID

(a) Remove the front wheel opening extension pad LH, engine under cover LH and front fender apron seal LH.

(b) Remove the refill plug and gasket from the automatic transaxle assembly.

Text in Illustration

(d) Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle assembly.

Text in Illustration

(e) Drain automatic transaxle fluid from the automatic transaxle assembly.

(f) Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle assembly.

Torque : 0.8 Nm (8 kgf-cm, 7 in-lbf)

Text in Illustration

(g) Using a 6 mm hexagon socket wrench, install a new gasket and the overflow plug to the automatic transaxle assembly.

Torque : 40 Nm (408 kgf-cm, 29 ft-lbf)

Text in Illustration

(h) Install a new gasket and the refill plug to the automatic transaxle assembly.

Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)

2. REMOVE FRONT DRIVE SHAFT ASSEMBLY

Removal

3. REMOVE TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the transaxle case oil seal.

SST : 09308-00010

4. REMOVE DRIVE SHAFT BEARING BRACKET Removal

5. REMOVE FRONT TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the front transaxle case oil seal.

SST : 09308-00010

6. INSTALL FRONT TRANSAXLE CASE OIL SEAL

(a) Using SST and a hammer, tap in a new front transaxle case oil seal.

SST : 09316-60011

09316-00011

Oil seal driven in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

NOTICE:
Check that the oil seal is installed in the correct direction.

(b) Coat the lip of the front transaxle case oil seal with MP grease.

7. INSTALL DRIVE SHAFT BEARING BRACKET Installation

8. INSTALL TRANSAXLE CASE OIL SEAL

(a) Using SST and a hammer, tap in a new transaxle case oil seal.

SST : 09316-10010

SST : 09950-70010

09951-07150

Oil seal driven in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

NOTICE:
Check that the oil seal is installed in the correct direction.

(b) Coat the lip of the transaxle case oil seal with MP grease.

9. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING LH Reassembly

10. INSTALL FRONT DRIVE SHAFT ASSEMBLY

Installation

11. ADD AUTOMATIC TRANSAXLE FLUID

Procedures