Removal

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSAXLE ASSEMBLY: REMOVAL

NOTICE:
If automatic transmission parts are replaced, refer to the Parts Replacement Compensation Table to determine if any additional operations are necessary Service Precautions.

1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

Removal

2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

3. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH Removal

4. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

5. REMOVE FRONT FRAME ASSEMBLY Removal

6. REMOVE WIRING HARNESS CONNECTOR

(a) Disconnect the wire harness clamp.





(b) Turn the lock lever and disconnect the connector from the wiring harness connector.

(c) Remove the 2 bolts and wiring harness connector from the automatic transaxle assembly.





7. SEPARATE WIRE HARNESS

(a) Remove the bolt and ground cable.





(b) Separate the park/neutral position switch connector and 7 wire harness clamps.

8. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

(a) Using the transmission jack attachment, set the automatic transaxle assembly on a transmission jack.

NOTICE:
* Secure the automatic transaxle assembly to the transmission jack using a suitable adapter, such as a rope or attachment.
* To prevent the oil pan from deforming, do not place any attachments onto the oil pan of the automatic transaxle assembly.
* Hold the engine assembly with a suitable adapter, such as a rope, during the operation.

(b) Remove the 9 bolts and automatic transaxle assembly.





NOTICE:
To prevent damage to the knock pins, do not pry between the automatic transaxle assembly and engine.

9. REMOVE TRANSMISSION OIL COOLER

(a) Remove the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose.





Text in Illustration





(b) Remove the 3 bolts and transmission oil cooler from the front engine mounting bracket.





10. REMOVE FRONT ENGINE MOUNTING BRACKET

(a) Remove the 3 bolts and front engine mounting bracket from the automatic transaxle assembly.





11. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

(a) Remove the 2 bolts and No. 1 transmission control cable bracket from the automatic transaxle assembly.





12. REMOVE WIRE HARNESS CLAMP BRACKET

(a) Remove the 4 bolts and 4 wire harness clamp brackets from the automatic transaxle assembly.





13. REMOVE TRANSMISSION CASE PLUG ASSEMBLY

(a) Remove the transmission case plug assembly from the automatic transaxle assembly.





(b) Remove the O-ring from the transmission case plug assembly.

14. REMOVE TORQUE CONVERTER ASSEMBLY

(a) Remove the torque converter assembly from the automatic transaxle assembly.