Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace the front drive outboard joint shaft assembly.

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

Removal

3. REMOVE FRONT FENDER LINER

HINT
Use the same procedure for the LH side and RH side Removal.

4. REMOVE FRONT SPEED SENSOR

(a) Disconnect the connector and disengage the clamp.





(b) Remove the bolt and front speed sensor clamp from the body.





(c) Remove the bolt, front flexible hose and front speed sensor clamp together from the shock absorber assembly.





Text in Illustration





(d) Disengage the clamp from the front shock absorber assembly.

(e) Remove the bolt and front speed sensor from the steering knuckle.





NOTICE:
* Prevent foreign matter from attaching to the front speed sensor tip.
* Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.