Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Service Precautions.

2. DISABLE BRAKE CONTROL Removal

3. REMOVE REAR WHEEL

4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Replacement

5. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG Removal

6. REMOVE REAR DISC Removal

7. DISCONNECT SKID CONTROL SENSOR WIRE

(a) Using a screwdriver, disconnect the connector from the rear axle hub and bearing assembly.





NOTICE:
Be careful not to damage the rear speed sensor.

8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

(a) Remove the rear axle hub and bearing assembly Removal.

HINT
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.
* If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.