Removal

U660E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE INLET NO. 2 AIR CLEANER Removal

3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

6. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Move the shift lever to N.

(b) Disconnect the wire harness clamp.





(c) Remove the nut from the control shaft lever.





(d) Remove the clip and disconnect the transmission control cable from the control cable bracket.

7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Disconnect the connector from the park/neutral position switch.

(b) Remove the nut, washer and control shaft lever from the control shaft.





(c) Remove the 2 bolts and park/neutral position switch from the control shaft.





NOTICE:
Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.