Seat Adjustment, Initiating on Board Diagnostic (OBD)

Seat Adjustment, Initiating On Board Diagnostic (OBD)

Test prerequisites:

- Voltage supply and fuses for the respective system OK.
- To initiate the On Board Diagnostic (OBD) the ignition must be switched on "Terminal 15 on".


NOTE:
- If the display remains blank, check VAG 1551 voltage supply according to wiring diagram.
- Additional operating in formation can be printed out depending on the program by pressing the HELP key of VAG 1551.
- The -> key is used for advancing the program sequence.
- The PRINT key is used for switching on the printer (warning lamp in key lights up).
- Connecting scan tool. Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks" under "Restraint Systems", Testing and Inspection


- Switch on ignition.
- Switch on printer with Print button (warning lamp in button lights up).
- Press key -1- for "Rapid data transfer" mode.

Indicated on display:


Rapid data transfer HELP
Enter address word XX


Address word for the seat adjustment: 36

Indicated on display:


Rapid data transfer HELP
Enter address word XX


- Press keys -3- and -6-.

Indicated on display after entering the address word 36:


Rapid data transfer Q
36 Seat adjustment


- Confirm entry with the Q button.

and then the following appears in the display:

Indicated on display:


Rapid data transfer
Tester sends the address word 36


The control unit identification will be shown on the scan tool VAG1551 display, e.g.:


3B1959760XX Seat adjustment FS 0001 ->


- Press -> key.

Indicated on display:


Rapid data transfer HELP
Select function XX