Diagnostic Mode 7: Check Test Of Parts Constantly Monitored

Diagnostic Mode 7: Check Test Results Of Components That Are Continuously Monitored

Function
This diagnostic mode indicates all stored DTCs of components and systems which are continuously monitored.
- Exhaust Malfunction Indicator Lamp (MIL) is not yet activated in instrument panel insert.
- A malfunction was stored in diagnostic mode 7, however this malfunction is not yet displayed in "Diagnostic mode 3: Check DTC memory".

Requirement
- There must not be any DTCs stored in DTC memory. Diagnostic mode 3: Check DTC memory. Diagnostic Mode 3: Check DTC Memory

Work procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Start engine and let run at idle.

NOTE: Only if engine does not start

- Operate starter for approx. 6 seconds. Do not switch ignition off afterward.
- Under address word 33, select "Diagnostic mode 7: Check test results of components that are continuously monitored".
The number of stored malfunctions or "0 malfunctions detected" is displayed.
- End diagnosis and switch ignition off.
- Repair stored malfunctions according to DTC table: P Code Charts
- SAE P0xxx-DTCs.
- SAE P1xxx-DTCs.
- SAE P2xxx-DTCs.
- SAE P3xxx-DTCs.

NOTE:
- The DTC table is sorted by SAE code.
- "EPC"-relevant malfunctions are also indicated by the warning lamp for Electronic Power Control ("EPC warning lamp") in the instrument cluster.
- Erase DTC memory after repairing malfunction. Diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data