Leak Detection Pump: Service and Repair

Leak Detection Pump (V144)

Removing

- Remove the right rear wheel housing liner.

- Disconnect the vacuum line - 2 -.






- Disconnect the connector - 3 -.

- Disconnect the vent line - 4 - by pressing the release button.

- Remove the cap nuts - 1 -.

- Remove the leak detection pump with the bracket.

Installing

Installation is performed in the reverse order of removal. When doing this note the following:

• The vent line - 4 - must engage audibly.

• Make sure the lines are connected securely.

Tightening Specifications